PCAN-Optoadapter
Plug-in Adapter for Decoupling CAN Networks

PCAN-Optoadapter
IPEH-002038 € 75,00

All prices are plus the at present valid value added tax!

Description

The PCAN-Optoadapter is a universal plug-on adapter to allow galvanic isolation of High-speed CAN bus systems.

Its integrated logic means that decoupling can be installed at any point in the CAN network.

The PCAN-Optoadapter can be used in CAN FD busses with data bit rates up to 2 Mbit/s and nominal bit rates up to 1 Mbit/s.

Technical Specifications

Pin assignment Female D-Sub Connector

Pin Pin assignment
1 5V Power supply
2 CAN-L
3 GND
4 Not connected
5 Not connected
6 GND
7 CAN-H
8 Not connected
9 Not connected

Pin assignment Male D-Sub Connector

Pin Pin assignment
1 Not connected
2 CAN-L
3 GND
4 Not connected
5 Not connected
6 GND
7 CAN-H
8 Not connected
9 Not connected
  • Plug-on adapter for decoupling a CAN bus for PEAK CAN interfaces
  • Galvanic isolation by DC/DC converters up to 500 V
  • Bit rates from 5 kbit/s up to 1 Mbit/s
  • High-speed CAN transceiver NXP PCA82C251
  • Suitable for the use in CAN FD busses with data bit rates up to 2 Mbit/s and nominal bit rates up to 1 Mbit/s
  • CAN bus connection via D-Sub, 9-pin (in accordance with CiA® 303-1)
  • LED for status indication of the supply voltage
  • 120-Ohm bus termination at the female D-Sub connector
  • 5-Volt power supply through pin 1 of the High-speed CAN connection. Nearly all CAN interfaces by PEAK-System can provide the required supply
  • Extended operating temperature range from
    -40 to 85 °C (-40 to 185 °F)


 

 

Scope of supply

  • Adapter in plastic casing
  • Manual in PDF format

Downloads

PCAN-Optoadapter manual

More

Additional information on other pages:

PEAK-System Forum: Section for the PCAN-Optoadapter for questions and support
The new standard CAN FD: support and compatible products