PCAN-PC/104-Plus Error Frames

[jptalledo]

I have a 500 kbps CAN bus with several nodes. I check the termination and it is 60 ohms. when there is traffic through the CAN Bus and the PCAN-PC/104-Plus is connected, error framer start appearing on the CANalyzer. If I disconnect the PCAN-PC/104-Plus module, there is no error messages.

Any ideas what could be wrong? I run ifconfig and check can0 interface and it shows 0 errors.

Thanks

[M.Maidhof]

Hi,

please check your CAN cables. Do you have a single or dual channel card? Which driver version do you have installed on your system. Will that problem also be there, when you call ifconfig can0 down? Please post the output of cat /proc/pcan

regards

Michael