This website uses cookies for analytics, for logins to the online shop and the forum, and for the handling of an order. By browsing this website you agree to the use of cookies. Detailed information on their use can be found in our privacy policy.

OK Privacy Policy

PCAN-AU5790

Bus Converter High-speed CAN to Single-wire CAN

PCAN-AU5790
IPEH-002040 € 95,00

All prices are plus the at present valid value added tax!

The PCAN-AU5790 bus converter establishes a connection between a High-speed CAN bus (ISO 11898-2) and a Single-wire CAN bus (SAE J2411). One of the most important potential applications of the bus converter is a simple connection between a PEAK CAN interface (e.g. PCAN-USB) and a Single-wire CAN bus.

Pin assignment Female D-Sub Connector

Pin Pin assignment High-speed CAN (82C251)
1 5V Power supply
2 CAN-L
3 GND
4 Not connected
5 Not connected
6 GND
7 CAN-H
8 Not connected
9 Not connected / optional +5V

Pin assignment Male D-Sub Connector

Pin Pin assignment Single-wire CAN (AU5790)
1 Not connected
2 Not connected
3 GND
4 Not connected
5 CAN
6 GND
7 Not connected
8 Not connected
9 VBAT
  • There are three different operating modes for the SW-CAN side which can be set using a sliding switch. Normal (33.3 kbit/s), High-speed (83.3 kbit/s) and Wake-up
  • Indicator LEDs for power supply (red) and wake-up signals (yellow)
  • 5-Volt power supply (150 mA) through HS-CAN connection (a current list of PEAK CAN interfaces with suitable supply voltage is available on request)
  • If the power supply has a current output lower than 150 mA, an additional 12-Volt supply is needed via the SW-CAN connector
  • Operating temperature range from
    0 to 70 °C (32 to 158 °F)
  • Adapter in plastic casing
  • Manual in PDF format

Other transceiver types on request

PCAN-AU5790 manual

German English

Additional information on other pages:

PEAK-System Forum: Section for the PCAN-AU5790 for questions and support