Ce site utilise des cookies à des fins d'analyse, de gestion de la connexion au site marchand, au forum et de traitement d’une commande. En continuant à naviguer sur ce site, vous acceptez cette utilisation. Vous trouverez des informations détaillées sur l'utilisation des cookies dans notre politique de confidentialité.

OK Confidentialité

PCAN-MicroMod FD - Firmware Version History

2020-08-02 - Version 1.9.10

Bug fixes:

  • Inversion of digital inputs did not work always correctly

2020-07-09 - Version 1.9.9

Bug fixes:

  • Motherboard Analog1: negative analog input values were incorrect in case a scale value not equal 1 was used

2020-06-05 - Version 1.9.8

  • In case the configuration of a DR module is invalid, but bit rate turn switches are valid, the CAN engine is initialized according to the switch position and the module runs in Standard (not CANopen) mode
  • The bit rate table for non-DR modules did contain a samplepoint of 87.5% for 500 kbit/s, CAN FD without BRSs. Corrected to a samplepoint of 80%

2020-05-12 - Version 1.9.7


  • Enhanced PEAK-Flash identification

Bug fixes:

  • PCAN-MicroMod FD Analog 1 modules with serial numbers from 00100 to 00143 might return incorrect Analog Input (16-bit) results in +/-20V measurement range (~2.5% too high)

2020-04-09 - Version 1.9.6


  • Added more configuration and board specific information when detecting the CPU module or the different motherboards with the configuration software
  • Added new module descriptions for PEAK-Flash


  • SSP (secondary sample point) of data bit rates is set to 80% for bit rates >= 2.5 Mbit/s
  • If no valid configuration is loaded the module blinks red and green alternately
  • Frequency of digital outputs in PWM mode was changed from integer to float

Bug fixes:

  • Updated the bit rate table due to some bugs
  • PWM measurement of channel 1,3, and 5 was inactive

2020-02-14 - Version 1.9.5

  • Improvement: New scale calibration for +/-20V range of 16-bit analog inputs

2019-12-18 - Version 1.9.2

  • Bug fix: Reading module information did not initialize transfer counter correctly

Version 1.9

  • Bug fix for digital inputs: Option to invert the signal was missing in the configuration

Version 1.8

  • I2C-EEPROM was removed. Binary configuration is now stored in QSPI flash

2019-08-28 - Version 1.6

  • First official release