We use cookies on our website to provide you with the best possible service and to further improve our website. By clicking the "Accept All" button, you agree to the use of all cookies. You can limit the cookies used by clicking on "Accept selection". Further information and an option to revoke your selection can be found in our privacy policy.

Necessary:

These cookies are necessary for basic functionality. This allows you to register on our website and forum or order products with our online shop.

Statistics:

With these cookies, we collect anonymized usage data for our website. For example, we can see which content is interesting for our visitors and which resolutions are used. We use the information to optimize our website to provide you with the best possible user experience.

Necessary
Statistics

show more

PCAN-MiniDiag FD - Firmware Version History

2020-01-28 - Version 1.4.12

  • Added support for a new hardware revision


PEAK-Flash tool with embedded firmware file

2020-01-22 - Version 1.4.11

Bug Fixes

  • In some cases a recessive CAN-Low voltage was displayed in the CAN Voltages menu as a dominant voltage
  • At module startup the voltage measured at D-Sub pin 9 was sometimes displayed wrong
  • In case that the differential CAN bus voltage was > 10 V or < -10 V the displayed value was sometimes not correct

2019-05-13 - Version 1.4.10

This log includes all changes of prior firmware versions releases since the last release. The firmware update is described in the latest PCAN-MiniDiag FD manual. Please note for devices that were calibrated with a firmware version older than 1.4.7: The calibration data is set to a predefined value. The measuring accuracy is improved nevertheless.

Improvements

  • Added the CAN differential voltage to the CAN Voltages device function
  • Added a new device function to show maximum, minimum, and average values of the differential voltages of the dominant and recessive levels
  • Reworked the text coloring. Added a color scheme for evaluation of bus load, termination, and error counter measurement values

Bug fixes

  • Improvement of automatic bit rate detection
  • If the bitrate was set manually, in some cases the CAN controller was initialized with the wrong bit rate
  • If the bitrate was set manually, in some cases the initially selected bitrate was not one which was currently set
  • After a successful bit rate detection sometimes the new bit rate was not displayed. Instead the initial text "Press * to set or <Enter> to detect the bit rate" was shown and the CAN controller was not initialized with the detected bit rate
  • It was possible that the ADC-mutex could cause a system shutdown
  • In some cases when the bit rate was set manually to non-iso mode, the CAN controller was initialized in iso-mode
  • In some cases the automatic bit rate detection failed for bit rates smaller than ~52kbit/s
  • Optimization of CAN voltage measurement

2019-01-29 - Version 1.4.0

First official release

Firmware updates prior to product release ...