This website uses cookies for analytics, for logins to the online shop and the forum, and for the handling of an order. By browsing this website you agree to the use of cookies. Detailed information on their use can be found in our privacy policy.

OK Privacy Policy

PCAN-MiniDiag FD - Firmware version history

2019-05-13 - Version 1.4.10

This log includes all changes of prior firmware versions releases since the last release. The firmware update is described in the latest PCAN-MiniDiag FD manual. Please note for devices that were calibrated with a firmware version older than 1.4.7: The calibration data is set to a predefined value. The measuring accuracy is improved nevertheless.

Improvements

  • Added the CAN differential voltage to the CAN Voltages device function
  • Added a new device function to show maximum, minimum, and average values of the differential voltages of the dominant and recessive levels
  • Reworked the text coloring. Added a color scheme for evaluation of bus load, termination, and error counter measurement values

Bug fixes

  • Improvement of automatic bit rate detection
  • If the bitrate was set manually, in some cases the CAN controller was initialized with the wrong bit rate
  • If the bitrate was set manually, in some cases the initially selected bitrate was not one which was currently set
  • After a successful bit rate detection sometimes the new bit rate was not displayed. Instead the initial text "Press * to set or <Enter> to detect the bit rate" was shown and the CAN controller was not initialized with the detected bit rate
  • It was possible that the ADC-mutex could cause a system shutdown
  • In some cases when the bit rate was set manually to non-iso mode, the CAN controller was initialized in iso-mode
  • In some cases the automatic bit rate detection failed for bit rates smaller than ~52kbit/s
  • Optimization of CAN voltage measurement


2019-01-29 - Version 1.4.0

First official release


Firmware updates prior to product release ...