We use cookies on our website to provide you with the best possible service and to further improve our website. By clicking the "Accept All" button, you agree to the use of all cookies. You can limit the cookies used by clicking on "Accept selection". Further information and an option to revoke your selection can be found in our privacy policy.

Necessary:

These cookies are necessary for basic functionality. This allows you to register on our website and forum or order products with our online shop.

Statistics:

With these cookies, we collect anonymized usage data for our website. For example, we can see which content is interesting for our visitors and which resolutions are used. We use the information to optimize our website to provide you with the best possible user experience.

Necessary
Statistics

show more

PCAN-USB Pro FD - Firmware Version History

2024-04-18 - Version 3.4.7

Bug fixes:

  • SOF and OUT-NACK IRQs disabled due to IRQ flooding on OUT-PINGs
  • 2nd device ID was not returned by vendor request (available on Linux)


PEAK-Flash tool with embedded firmware file

2022-03-28 - Version 3.4.4

  • CAN Core updated
  • Option added: Send ACK as transmitter
  • Option added: Generate time stamp at start of frame
  • Option added: Ignore BRS frames as receiver
  • LIN commands improvements
  • LIN Wake-Up was not working after LIN power cycles
  • Bugfix: Status Frame suppressed when leaving reset mode during BusOff
  • Internal Firmware improvements

2017-08-31 - Version 3.2.0

  • Bugfix for CAN bitrate prescaler
  • Mode added to force CAN 2.0 A/B
  • Timestamps for RCV frames at bit 6 of end-of-frame

Version 3.1.1

  • Bugfix CAN core, bad TX data due to RAM pointer increment
  • TX pause added for transmit delay

Version 3.1.0

  • Bugfix CAN core, bad TX data due to RAM pointer reset

Version 3.0.0

  • New CAN core Gen 3 included (new implementation of BSP/BTL, tested with Bosch Ref CAN model)

Version 2.3.1

  • Bugfix/modification for timestamp system (CAN/LIN with offset)

Version 2.3.0

  • Firmware version change for USB MSD bootloader

Version 2.2.1

  • Bugfix: bad frames in CAN FD ISO mode with DLC=0

Version 2.2.0

  • Bugfix "error frames in listen-only mode"
  • USB descriptor for LIN endpoints modified
  • USB "other descriptor" modified

Version 2.1.0

  • Modification USB suspend
  • Fast-forward option added

Version 2.0.3

  • Flash mode depends on password
  • LED toggle for locked CAN

Version 2.0.2

  • CAN BusOff issue fixed

Version 2.0.1

  • USB suspend reactivated

Version 2.0.0

  • CAN core with ISO/Non-ISO support
  • OEM area added (OEM_CODE, password ...)

Version 1.1.6

  • Modification for USB packet sizes of LIN endpoints (limited FIFO size of USB controller, data corruption on parallel CAN/LIN communication)

Version 1.1.5

  • FPGA modification for I/O signaling