Power routed to Pin 2 of M12 CAN connectors

6-Channel CAN FD Interface for High-Speed USB 2.0

Power routed to Pin 2 of M12 CAN connectors

Postby dfcossio » Wed 6. Dec 2017, 17:49

Hi,
I was wondering if it is possible to route the voltage of the external power supply to the pin 2 of the CAN M12 connectors on the PCAN-USB X6 so I can provide power to my CAN sensors using the same cable.

I've attached the pin out of my CAN sensor

CAN sensor pin out.JPG
CAN sensor pin out.JPG (18.55 KiB) Viewed 1000 times


Thanks in advance!

Diego
dfcossio
 
Posts: 1
Joined: Wed 6. Dec 2017, 17:32

Re: Power routed to Pin 2 of M12 CAN connectors

Postby U.Wilhelm » Thu 7. Dec 2017, 09:19

Sorry, this is NOT possible ! The GND (U- Pin 3) could not be used, because this is the isolated GND of the CAN Transceiver and it is NOT connected to the Supply GND !
--------------------------------
PEAK-System Technik
Technical Support Team
support@peak-system.com
-------------------------------
User avatar
U.Wilhelm
Sales & Support
Sales & Support
 
Posts: 1009
Joined: Fri 10. Sep 2010, 18:34
Location: Darmstadt


Return to PCAN-USB X6



This website uses cookies for analytics, for logins to the online shop and the forum, and for the handling of an order. By browsing this website you agree to the use of cookies. Detailed information on their use can be found in our privacy policy.

OKPrivacy Policy