PCAN-LIN

Interface for LIN, CAN, and RS-232

PCAN-LIN High-speed CAN
IPEH-002025	€ 245,00

PCAN-LIN Low-speed CAN
IPEH-002028	€ 245,00

PCAN-LIN High-speed CAN opto-decoupled
IPEH-002029	€ 295,00

All prices are plus the at present valid value added tax!

The PCAN-LIN module enables CAN, LIN, and serial participants to communicate. The module is supplied in a plastic casing and includes firmware which enables data to be exchanged between the different bus systems. Various modes can be set up with the aid of configuration software. Then for instance the module acting as the LIN master can request data and route the incoming LIN data to the CAN bus and/or the serial interface. Data can be routed between CAN and LIN with an ID offset.

Pin assignment Female D-Sub Connector

Pin	Pin assignment RS-232
1	Not connected
2	TxD (RS-232-level)
3	RxD (RS-232-level)
4	Not connected
5	GND
6	Not connected
7	Not connected
8	Not connected
9	Not connected

Pin assignment Male D-Sub Connector

Pin	Pin assignment CAN/LIN
1	V_Bat 9 - 30V (I_max ~ 130mA)
2	CAN-L
3	GND
4	LIN data
5	Not connected
6	GND
7	CAN-H
8	Not connected
9	Not connected

General-purpose gateway (or router when using Acceptance Code / Acceptance Mask feature) from:
- RS-232 to LIN (and back)
- CAN to LIN (and back)
- RS-232 to CAN (limited bandwidth)
CAN bit rates up to 1 Mbit/s
Complies with CAN specifications 2.0 A/B
LIN bit rates of 1 – 20 kbit/s
Transmitting/receiving LIN 1.x and 2.x frames
Available for use as LIN master or slave
Simulation of LIN slaves. Data can be changed via CAN frames
Processing a user-definable LIN ID list (scheduler with limited number of entries)
Individual LIN frames can be initiated via CAN or RS-232
Voltage supply from 9 to 30 V
Extended operating temperature range
from -40 to 85 °C (-40 to 185 °F)

Optionally available:

High-speed (ISO 11898-2) or Low-speed (ISO 11898-3) CAN transceiver module
Galvanic isolation between RS-232 and CAN/LIN up to 1 kV (only for High-speed CAN)