This website uses cookies for analytics, for logins to the online shop and the forum, and for the handling of an order. By browsing this website you agree to the use of cookies. Detailed information on their use can be found in our privacy policy.

OK Privacy Policy

PEAK-Flash Version History

2020-08-28 - Version 1.1.1


  • Updated embedded firmware for PCAN-MicroMod FD to v1.9.10
  • The Device ID of a PCI hardware is shown if the installed device driver supports this feature
  • A text is shown in the User Interface when an error occurs while identifying a USB or PCI hardware

Bug fixes:

  • MU-Thermocouple1 module was not flashable due to a problem with CRC calculation
  • Fixed a bug where not having a PCI device driver would lead to an application crash


2020-05-20 - Version 1.1.0


  • CPU load reduced
  • The list of embedded firmware files is now sortable
  • When flashing an USB adapter via Remote Desktop, the user might not have sufficient privileges to access the removable disk the adapter exposes while in flash mode. Now PEAK-Flash can restart itself with Administrator privileges and resume the flash process
  • Embedded firmware for PCAN-MicroMod updated to v2.27
  • Embedded firmware for PCAN-MicroMod FD updated to v1.9.7
  • Several smaller user interface improvements and other internal optimizations

Bug fixes:

  • The version number displayed in the Select Firmware step as the current firmware version was incorrect under certain conditions
  • Some PC interfaces or CAN modules were not automatically reset after flashing
  • Detecting modules on a CAN bus sometimes caused the program to crash
  • Several minor bug fixes

2020-03-19 - Version 1.0.1


  • Added support for PCAN-Router Pro FD
  • Updated embedded firmware for PCAN-MicroMod FD to v1.9.5
  • Updated embedded firmware for PCAN-MIO to v3.3.8
  • Updated embedded firmware for PCAN-Router Pro to v1.15.1
  • General user interface improvements

Bug fixes:

  • Fixed error in PCAN-MicroMod FD parameters
  • Fixed bug where unknown CAN modules would cause an error to be shown
  • Fixed bug where CAN module firmware files with versions that had more than three numbers (eg. caused the application to crash
  • PCAN-USB FD and PCAN-USB Pro FD were always shown as flashable, although the application can only flash them with MSD mode (bootloader >= 2.x and firmware >= 2.3.x)
  • Several minor bug fixes

2020-01-31 - Version 1.0.0

  • First release