This website uses cookies for analytics, for logins to the online shop and the forum, and for the handling of an order. By browsing this website you agree to the use of cookies. Detailed information on their use can be found in our privacy policy.

OK Privacy Policy

Virtual PCAN-Gateway Version History

2017-09-14 - Version 1.3.1

Improvements:

  • The status of the Gateway CAN channels is now forwarded to the PCAN-LAN driver (BUS PASSIVE/WARNING/etc.)
  • The configuration tool can now be used as command-line tool for some actions:
    • /reload: causes a reload of all configured routes. Same as clicking the Reload button under Device / Configuration
    • /routeson: turns all configured routes on. Same as context menu command 'Switch ALL Routes On' under Routing / Manage Routes
    • /routesoff: turns all configured routes off. Same as context menu command 'Switch ALL Routes Off' under Routing / Manage Routes
  • The use of the port 45321 when creating or editing routes within the configuration tool is now denied (marked as reserved)

Bug fixes:

  • Routes were unable to connect if a PCAN-Ethernet Gateway was idle while the PC was being started or rebooted. This caused the registration of an invalid IP address
  • Incoming routes (from device to PC) could not connect if they were initialized before the network (network adapter or LAN cable) was activated


2017-02-01 - Version 1.3.0

Improvement:

  • It is now possible to use different IP addresses on the same network card

Bug fixes:

  • VPOI-Service dependencies were adjusted to avoid race conditions with the Windows firewall at startup
  • Fixed inconsistencies concerning the font in the Virtual PCAN-Gateway Configuration user interface


2016-01-26 - Version 1.2.0

Improvements:

  • It is now possible to define up to 16 routes
  • Added a command in the Configuraton Tool (Device | Configuration) to force a reload of the routes (behavior is similar to restarting the service)
  • Information about the firmware version is now available
  • Bit rate and CAN Listen-only changes in a PCAN-Gateway device are now communicated to the service and forwarded to the driver (PCAN-Gateway software package 2.6.0 required)

Bug fixes:

  • Fixed access violation when doing the "Join routes" process in the configuration tool
  • Fixed access violation when invocating the context menu on the route list in the configuration tool, after deleting a route
  • Fixed access violation when a wrong focus on the "Manage Routes" list in the configuration tool was evaluated
  • The service excecutable crashed sometimes while finalizing


2015-11-06 - Version 1.1.0

Improvements:

  • The communication protocol between PCAN-Gateways and the Virtual PCAN-Gateway was enhanced
  • Minor improvements in the user interface of the Configuration Tool
  • General code optimizations

Bug fixes:

  • While editing a route in the Configuration Tool the left side menu is no longer blocked
  • Double plugged-in route problem fixed
  • Problem that was causing abandoned routes to be shown was fixed
  • Problem that didn't let active routes to get connected was fixed
  • Problem solved that sometimes caused the service to crash at finalization time
  • The 8th defined route was lost after restarting the service. After that it was impossible to define 8 routes, even after deleting all of them


2015-07-01 - Version 1.0.1

  • Improvement for the Virtual PCAN-Gateway Manager: The communication protocol between routes and driver was enhanced
  • Bug fix for the Virtual PCAN-Gateway Manager: Listen-Only status of CAN channels were being not forwarded to the driver
  • Bug fix: The link to call the PEAK Control Panel Applet was not working in some scenarios


2015-06-17 - Version 1.0.0

  • First Release